Before using the BuzzFinder, you should read the instructions carefully.
First, test your device by pressing the button at the bottom of the remote control. The device should make a sound.
Attach a sticker or fasten a cord to the device and place it on the desired object.
Finding an Object
Find an object by pressing the button at the bottom of the remote control. If the object onto which the sound device is attached is within range, you will hear a sound every four seconds within a 30 second span. You may repeat this action to hear the sound again. Once you have found the object, press the button at the bottom of the remote once again to stop the sound. If the object is out of range, you will hear three beeps from the remote control.
Finding a Remote Control
Find a remote control by pressing the button at the top of the remote control. If the other remote control is within range, you will hear a sound every four seconds within a 30 second span. You may repeat this action to hear the sound again. Once you have found the other remote control, press the button at the top of the remote once again to stop the sound. If the other remote control is out of range, you will hear three beeps from the remote control.
*Some factors may alter the performance of this device, such as interference between the remote control and the sound device caused by concrete walls, numerous walls, or low battery charge.
Changing the Battery
Each module comes with a battery. When you hear three consecutive beeps, it means you need to change the battery. This signal will repeat every 60 minutes. You must replace the battery if you wish to continue using your BuzzFinder.
To replace a module’s battery, you will need a screwdriver. The battery is located at the back of the device. Before opening the device, make sure you touch metal to remove any electrostatic charges from your body. Such charges may cause permanent damage to the microchip. Then, open the lid, remove the microchip, and use your screwdriver to remove the battery by taking it out of its socket. Insert a new battery in the socket, making sure the positive sign (+) is on top.
Fixing a Conflict Between Devices
Even though your BuzzFinder is programmed with unique identification, it does not mean it cannot conflict with another owner's BuzzFinder. To correct the problem, collect the two conflicting remote controls and the sound device and press both buttons on one of the remote controls simultaneously. Each module should emit a sound. This indicates that your problem is resolved.
Changes or modifications not expressly approved by SOS Finder Inc. could void the user’s authority to operate the equipment
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.